12 volt Engine Oil Sump Pump

Do it yourself engine oil change on your boat inboard engine
We have used one of these electric units for the past 14 years since we launched our boat.
It’s never missed a beat!
Imported directly from the manufacturer by Cruising Electronics, to our specifications

Process (instructions are included with the pump):
Simply run the engine until quite warm. Turn the engine off and allow to stand for 10 minutes.
Remove the dipstick, and insert the inlet tube of the pump into the dipstick hole.
Place the outlet tube of the pump into an empty oil container.Turn the Power on.
That’s it!
Specifications

• Johnson Pump Motor
• Voltage  12 Volts DC
• Current   5 Amps
• Inlet tube 6.3mm (1/4”) dia. (suits smallest dipsticks) x 1 meter long (39”)
• Outlet tube 10.0mm (3/8”) dia. x 1 meter (39”)
• Spare tube-to-pump connectors supplied 
• Power cable with attached battery clips stows in rear compartment of pump
• On/Off switch on top of unit
• Magnetised base for easy mounting to motor if required
• Drains 4 litres in approximately 8 minutes
• Not recommended for commercial use or sumps over 8L capacity

12 Month Full Replacement Warranty